Dave WI6R shows off his Hammond 1402DV (V for Vented since the heat sinks are inside).
It’s tight with the Volume Control mounted in between the display and the extrusion. So the PCB is mounted as close as you can get to the right side extrusion, then mark for the display and pot, with the encoder centered between the display and right side.
Dave used his own connectors for Mic, Headphones and Paddle and a Power Pole power connection on the rear panel. On the far left is the stock BNC antenna connector.
There was room to later mount a USB cable as show. Dave thinks he should have centred the Power Pole connector with the USB rear panel connection, but that’s what happens when you add things in later …