A mod developed by Gary N3GO (and required for Full QSK) also mitigates the Tx and Rx pop/thump noises in SSB mode. This mod should work fine with the existing relays and with or without other mods, but has yet to be verified by others.
A complete top board for µBitx
Martin Held AE7EU has been very busy designing a top tier board for the µBitx main board.
The board interfaces via the standard connectors to the main board of the uBitx. Martin’s top board adds essential features, such as speech compression, an integrated Teensy 3.2 processor, an attenuator and an auto antenna tuner. The front panel break-off from the board simplifies construction and makes the form factor as small as possible.
We look forward to seeing Martin’s report on how the board performs in practice. It is likely we will see a few changes to the board before it becomes available to purchase!
In a post to the BITX20 list Martin identified four options for release:
1) Release the board files, schematic, design files/gerbers, BoM and let someone in China clone it, walk away.
2) Same as #1, but just sell bare PCB’s.
3) Sell PCB’s with all SMT components installed, and a baggie of TH parts, toroids, and couple feet of magnet wire.
4) Sell the entire thing fully assembled ($$$).
It is likely that either options 2) and 3) will be favoured by the amateur community, based on initial feedback to Martin.
µBitx mods website under construction
Tired of searching through the Bitx20 iogroups emails to find mods for your µBitx transceiver?
This website should make it much easier to identify potential mods for your own µBitx, and get the information you need to do the construction! It is not intended to replace the group culture, but to make it easier to reference mods suggested by group members.